Installation How its Done For most vehicles, installation takes about two hours, and many installations can be completed in less time. Our installers are trained professionals utilizing both their skills and creativity to successfully install the Ravelco Anti Theft Device. Because alarms and other systems require power to operate, those installations often require cutting up to 10 wires inside your car. The Ravelco requires no power, and therefore uses fewer wires, making the Ravelco Anti-Theft Device the least invasive system you can install in your vehicle. We will custom mount the device in a variety of ways Why thieves will move on It’s impossible for thieves to hotwire a vehicle, when they can’t find the right wires. Most vehicle security systems connect to your car’s wires under your dashboard – the first place thieves look to hotwire your car. Because Ravelco hides connections in the engine compartment, the Ravelco wires are hidden among your vehicle’s existing wires. It would take hours for a thief to go through your vehicle’s electrical system and sort out the connections. Most thieves want to break in, start your car, and drive away within minutes. The base unit of the Ravelco Anti-Theft Device is installed in an easily accessible area underneath,flush mounted in the dashboard or hidden in a custom location. A protective steel tube protects the Ravelco wires from the rear of the base through to the engine compartment, where the connections are hidden from sight. Contact us for more info